Includes-
- Red One Camera body
- P/L Mount
- Compact Flash Module
- 2x 130W Li-Ion Batteries
- Dual Li-Ion Battery Charger
- Red Base Production Pack
- All Cables

Record 2540 progressive at up to 60 fps RAW. With 4520 X 2540 pixels, Mysterium™ puts pure digital Ultra-High Def in the palm of your hand. RED ONE™ and REDCINE™ also support down-sampling to 1080p and 720p for in-field monitoring and compatibility with non-linear editors. You get the same breathtaking field of view and selective focus found on film cameras. Mysterium™ boasts a greater than 66db Signal to Noise Ratio thanks to its large 29 sq. micron pixels. And 12,065,000 pixels deliver resolution that can only be called Ultra High Definition.

click here for more info on Red

Includes:
- Dual 160 GB 2.5” SATA Hard Disk Drives
- All Cables

includes:

* Camera Read / Write Module for Digital Cinema CompactFlash media

Includes:

* (1) Universal Mount
* (1) RED handle (Right)
* (1) RED Bottom Plate
* (1) Shoulder Dovetail
* (1) Top Mount
* (1) Top Handle
* (1) RED Cradle (including Battery Plate)
* (2) 18’’ Steel Rods

Allows use of Arri compatible accessories that are 15mm 100mm spacing to be used with Red One.

Comes with:

Red Arri 15mm Baseplate
Dovetail
Pair of 15mm Rods

Allows use of Arri compatible accessories that are 19mm 104mm spacing to be used with Red One.

Comes with:

Red Arri 19mm Baseplate
Dovetail
Pair of 19mm Rods

Includes:
RED ARM adjustable mount arm
Interface cable – 1ft

The RED Electronic Viewfinder [EVF] is an 8-bit color 1280 x 848 viewfinder that interfaces with the camera via a proprietary 17-pin connector. The viewfinder has a tally light that can be enabled or disabled via software. It also has an interface control system [three buttons and a click-knob] built into the side of the viewfinder.

The viewfinder displays the captured image along with look around, frame line overlays and status indicators. While the resolution is 1280 x 848, the image display is 720p. The extra pixels are saved for status indicators below the image. The EVF can also display the focus assist, waveform monitors, histogram, false color exposure indicator or zebra exposure lines. It also displays the menu system when it is activated; as well playback when the camera is playing back completed takes.

The viewfinder mounts to the camera body or RED RAIL system via the RED ARM. The EVF has four ¼”-20 threaded mounting points that allow it to be attached to the RED ARM in different places, depending on the desired setup.

That said, the EVF is not limited to mounting on the RED ARM. Since it uses standard threaded mounting points, it can be mounted to any accessory arm that has the same thread. The EVF’s only an accessory away from interfacing with a standard eyepiece leveling system. There is complete freedom here.

Since the EVF does not require an optical connection to the camera, it can be mounted or held anywhere on or around the camera. There are 3 foot and 10 foot extension cables available, so the EVF can live up to 10 feet away from the camera.

Includes:
RED ARM adjustable mount arm
Interface cable – 1ft

The RED LCD is an 8-bit color 1024 x 600 5.6” display that interfaces with the camera via a proprietary 17-pin connector. The screen was prototyped out of aluminum, but may change to ABS plastic when it ships. On the top of the LCD is a power button and three interface control buttons.

Like the viewfinder, the LCD displays the captured image along with look around, frame line overlays and status indicators. Since a 16:9 image would be 1024 x 576 pixels, the extra pixels on the display are saved for these indicators. The LCD can also display the focus assist, waveform monitors, histogram, false color exposure indicator or zebra exposure lines. It also displays the menu system when it is activated; as well playback when the camera is playing back completed takes.

Its ability to display all of these functions [most notably the focus assist] makes it an amazing tool for a focus puller. Not only will they have a very high resolution “video tap” of what’s going on in the camera, they’ll also have the ability to display the focus assist or blow the image up to a 1:1 pixel ratio for those extremely critical focus shots.

The LCD is quite bright, being designed for use indoors or outdoors. While a sun shade wouldn't be a bad idea, it is apparently quite viewable in direct sunlight.

The LCD mounts to the camera body or RED RAIL system via the RED ARM – it has one ¼”-20 threaded mounting point on the bottom. There are literally dozens of places to mount the LCD with RED ARM on the RED RAIL system.

There are 3 foot and 10 foot extension cables available, so the LCD can live up to 10 feet away from the camera.

Includes:
RED ARM adjustable mount arm

The RED ARM is a small, stunningly sturdy magic arm for mounting the viewfinder, LCD or other accessories. It has a male ¼”-20 thread on each side.

The ARM has three ball joints, all of which lock via the thumbscrew in the middle. There really isn’t much to say about the ARM that hasn’t been said already: It’s small, flexible, sturdy and well built.